Kawasaki Ninja Service Manual: Air Cleaner

Nozzle Assy Assembly

Before assembling, blow away dirt or dust from the delivery pipes [A] by applying compressed air [B]. Replace the O-rings [A] of the joint pipe [B] with new ones. Apply engine oil to ...

Air Cleaner Element Inspection

Remove the air cleaner element (see Air Cleaner Element Replacement in the Periodic Maintenance chapter). Visually check the element [A] for tears or breaks. If the element has any tears or ...

Other materials:

Rear Master Cylinder Installation
Replace the washers that are on each side of hose fitting with new ones. Install the brake hose [A]. Touch the brake hose to the stopper [B] of the rear master cylinder. Tighten: Torque - Brake Hose Banjo Bolt: 25 N·m (2.5 kgf·m, 18 ft·lb) Install the master cylinder, the brack ...

Shift Fork Guide Pin/Drum Groove Wear Inspection
Measure the diameter of each shift fork guide pin [A], and measure the width [B] of each shift drum groove. If the guide pin on any shift fork is less than the service limit, the fork must be replaced. Shift Fork Guide Pin Diameter Standard: 6.9 7.0 mm (0.272 0.276 in.) Service Limit: ...

Oxygen Sensor Installation (Equipped Models)
NOTICE Never drop the oxygen sensor [A] especially on a hard surface. Such a shock to the unit can damage it. Do not touch the sensing part [B] to prevent oil contact. Oil contamination from hands can reduce sensor performance. Tighten: Torque - Oxygen Sensor: 25 N·m (2.5 kgf·m, 18 ...