Fit the projections [A] of the duct into the slits [B] on the air cleaner housing.
Torque - Air Cleaner Housing Duct Screws: 1.1 N·m (0.11 kgf·m, 10 in·lb)
Crankshaft Sensor Peak Voltage Inspection
Refer to the Crankshaft Sensor Peak Voltage Inspection
in the Electrical System chapter.
If the reading is within the standard, remove the ECU and
check the wiring for continuity between harness connectors.
Special Tool - Hand Tester: 57001-1394
Disconnect the ECU and sensor connector ...
Coolant Level Inspection
NOTE
Check the level when the engine is cold (room or ambient
temperature).
Check the coolant level in the reserve tank [A] with the
motorcycle held perpendicular (Do not use the sidestand).
If the coolant level is lower than the “L” level line [B], remove
the upper fairing assembly (s ...
Oil Cooler Removal
Remove:
Coolant (Drain, see Coolant Change in the Periodic
Maintenance chapter)
Engine Oil (Drain, see Engine Oil Change in the Periodic
Maintenance chapter)
Lower Fairings (see Lower Fairing Removal in the Frame
chapter)
Water Hose Ends [A] (Disconnect)
Remove:
Oil Cool ...