Kawasaki Ninja Service Manual: Air Intake Duct Disassembly (US, CA and CAL Models)

Kawasaki Ninja Service Manual / Fuel System (DFI) / Air Line / Air Intake Duct Disassembly (US, CA and CAL Models)

Air Intake Duct Disassembly (US, CA and CAL Models)


Air Intake Duct Installation
Check that the pad [A] is in place on the air intake duct. Apply a non-permanent locking agent to the threads of the air intake duct mounting bolts, and tighten them. Run the lead correctly ( ...

Air Intake Duct Assembly (US, CA and CAL Models)
Install the dampers [A] and seal [B] as shown in the figure. Fit the holder [C] to the air intake ducts [D]. Projections [E] and Holes [F] Grooves [G] and Ribs [H] Tighten: Torque - Ai ...

Other materials:

Steering Stem Warp Inspection
Whenever the steering stem is removed, or if the steering can not be adjusted for smooth action, check the steering stem for straightness. If the steering stem [A] is bent, replace the steering stem. Stem Cap Deterioration, Damage Inspection Replace the stem cap if its oil seal [A] s ...

Wear Inspection
Remove the left front footpeg bracket bolts. A. Front Footpeg Bracket B. Bolts Remove the bolts and chain cover. A. Bolts B. Chain Cover Stretch the chain taut either by using the chain adjusters, or by hanging a 10 kg (22 lb) weight on the chain. Measure the lengt ...

Engine Sprocket Installation
Replace the sprocket washer and axle cotter pin. Install the engine sprocket onto the output shaft. Apply molybdenum disulfide oil solution to the threads and seating surface of the engine sprocket nut. Tighten: Torque - Engine Sprocket Nut: 145 N·m (14.8 kgf·m, 107 ft·lb) NOTE ...