Air Intake Solenoid Valve Unit Test (Other than US, CA and CAL Models)
Clutch Cover Assembly
Replace the needle bearings and oil seal with new ones.
NOTE
Install the needle bearings so that the manufacture’s
mark face out.
Install the needle bearings [A] and oil seal [B] position as
shown in the figure.
Press the upper and lower bearings so that the bearing
surface [ ...
Water Pump Impeller Disassembly/Assembly
Remove the water pump impeller (see Oil Pump Removal
in the Engine Lubrication System chapter).
The sealing seat and rubber seal may be removed easily
by hand.
Apply coolant around the surfaces of the rubber seal and
sealing seat.
Install the rubber seal [A] and sealing seat [B] into ...
For Primary Fuel Injectors
Remove the air cleaner housing (see Air Cleaner Housing
Removal).
Disconnect the primary fuel injector connector [A].
Connect a digital meter to the terminals in each primary
fuel injector [A].
Measure the primary fuel injector resistance.
Primary Fuel Injector Resistance ...