Kawasaki Ninja Service Manual: Air Intake Solenoid Valve Removal (Other than US, CA and CAL Models)

Kawasaki Ninja Service Manual / Fuel System (DFI) / Air Line / Air Intake Solenoid Valve Removal (Other than US, CA and CAL Models)

Air Intake Solenoid Valve Removal (Other than US, CA and CAL Models)


Air Intake Duct Assembly (Other than US, CA and CAL Models)
Install the seals [A] as shown in the figure. Fit the projections [A] of the air intake valve to the hole [B] of the air intake ducts. Tighten: Torque - Air Intake Duct Assembly Sc ...

Air Intake Solenoid Valve Installation (Other than US, CA and CAL Models)
Run the lead and hoses correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter). Tighten: Torque - Air Intake Solenoid Valve Nut: 7.0 N·m (0.71 kgf·m, 62 in·lb) A ...

Other materials:

Safe riding technique
The points given below are applicable for everyday motorcycle use and should be carefully observed for safe and effective vehicle operation. For safety, eye protection and a helmet are strongly recommended. You should be aware of and verify the applicable safety regulations in force prior ...

Multifunction Display
The multifunction display indicates the following modes. Odometer Trip meter A Trip meter B Current Mileage Average Mileage Fuel Consumption Stop Watch These display modes can be shifted by pushing the upper button. NOTE The “FUEL” warning can be indicated if the ...

Cylinder Head Cover Removal
Remove: Air Suction Valves (see Air Suction Valve Removal) Throttle Body Assy (see Throttle Body Assy Removal in the Fuel System (DFI) chapter) Stick Coils (see Stick Coil Removal in the Electrical System chapter) Remove the clamps [A]. Turn up the front side of the heat insulation ...