Special Tool - Hand Tester: 57001-1394
Air Intake Solenoid Valve Resistance Standard: 22 26 Ω at 20°C (68°F)
If the resistance reading is out of the specified value, replace it with a new one.
If the air intake solenoid valve does not operate as described, replace it with a new one.
NOTE
To check air flow through the air intake solenoid valve, just blow through the air intake solenoid valve hose (intake side) [C].
Air Intake Solenoid Valve Circuit
1. Ignition Switch
2. Air Intake Solenoid Valve
3. Joint Connector A
4. ECU
5. Battery
6. Main Fuse 30 A
7. ECU Fuse 15 A
8. Starter Relay
9. Frame Grounds
10. ECU Main Relay
11. Relay Box
12. Ignition Fuse 15 A
13. Fuse Box 1
14. Joint Connector F
Hub Bearing Installation
Before installing the hub bearings, blow any dirt or foreign
particles out of the hub with compressed air to prevent
contamination of the bearings.
Replace the bearings with new ones.
Install the bearings by using the bearing driver set which
does not contact the bearing inner race.
...
Tail/Brake Light (LED) Removal/Installation
Remove:
Upper Seat Cover (see Seat Cover Removal in the
Frame chapter)
Disconnect the tail/brake light connector [A].
Remove:
Tail/Brake Light Mounting Screws [A]
Bolts [B] and Brackets [C]
Bolt [D]
Remove the tail/brake light [A].
Bring down the rear fender rea ...
Ignition System
WARNINGThe ignition system produces extremely
high voltage.
Do not touch the spark plug, ignition coil or ignition
coil lead while the engine is running, or you
could receive a severe electrical shock.
NOTICE
Do not disconnect the battery cables or any other
electrical ...