Kawasaki Ninja Service Manual: Air Line

Air Cleaner Housing Assembly

Install the ducts to the air cleaner housing. Fit the projections [A] of the duct into the slits [B] on the air cleaner housing. Tighten the screws [A]. Torque - Air Cleaner Housing ...

Air Intake Duct Removal

Remove: Upper Fairing Assembly (see Upper Fairing Assembly Removal in the Frame chapter) Meter Bracket (see Meter Unit Removal/Installation in the Electrical System chapter) Immobilizer A ...

Other materials:

System Components
1. FI ECU The FI ECU analyzes the motorcycle conditions based on the signals from the front/rear wheel rotation sensors and FI sensors (such as the crankshaft sensor and main throttle sensor), and controls engine power by reducing the number of ignition and retarding the ignition timing. The m ...

Additional Considerations for High Speed Operation
Brakes: The importance of the brakes, especially during high speed operation, cannot be overemphasized. Check to see that they are correctly adjusted and functioning properly. Steering: Looseness in the steering can cause loss of control. Check to see that the handlebar turns freely but ha ...

Oxygen Sensor Removal (Equipped Models)
Remove: Fuel Tank (see Fuel Tank Removal in the Fuel System (DFI) chapter) Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Disconnect the oxygen sensor lead connector [A]. NOTICE Do not pull strongly, twist, or bend the oxygen sensor lead. This may cause the wi ...