Air Switching Valve Operation Test
Refer to the Air Suction System Damage Inspection in the Periodic Maintenance chapter.
Air Switching Valve Unit Test
Special Tool - Hand Tester: 57001-1394 Air Switching Valve Resistance Standard: 20 24 Ω at 20°C (68°F)
If the resistance reading is out of the specified value, replace it with a new one.
If the air switching valve dose not operate as described, replace it with a new one.
NOTE
To check air flow through the air switching valve, just blow through the air switching valve hose (intake side) [C].
Air Switching Valve Circuit
1. ECU
2. Air Switching Valve
3. Ignition Switch
4. Joint Connector F
5. Joint Connector A
6. Fuse Box 1
7. Ignition Fuse 15 A
8. Relay Box
9. ECU Main Relay
10. Frame Ground 1
11. Frame Ground 3
12. Starter Relay
13. ECU Fuse 15 A
14. Main Fuse 30 A
15. Battery
16. Engine Ground
Rear Master Cylinder Removal
Unscrew the brake hose banjo bolt [A] and remove the
brake hose (see Brake Hose and Pipe Replacement in
the Periodic Maintenance chapter).
Remove:
Rear Master Cylinder Mounting Bolts [B]
Foot Guard [C]
Screw and Stopper [D]
Bolt [E]
Front Footpeg Bracket Bolts [F]
Cable Guide [G ...
ZX1000JB/KB Models
1. Run the fuse box 2 lead in front of the rib for the fuse box 2.
2. Seat Lock Cable
3. Hook the licence plate light lead and the left turn signal light lead on
the projection of the tool
kit case.
4. Rib for Fuse Box 2
5. Run the starter relay lead in back of the rib for the fuse box 2 ...
Oil Pressure Relief Valve Inspection
Remove the oil pressure relief valve (see Oil Pressure
Relief Valve Removal).
Check to see if the valve [A] slides smoothly when pushing
it in with a wooden or other soft rod, and see if it comes
back to its seat by spring [B] pressure.
NOTE
Inspect the valve in its assembled stat ...