NOTE
Be sure the battery is fully charged.
Do not disconnect the connectors.
Special Tool - Needle Adapter Set: 57001-1457
Amplifier Input Voltage Connections to Amplifier Connector: Digital Meter (+) → BR/W lead Digital Meter (–) → BK/Y lead
If the reading is out of the standard, check the wiring (see Immobilizer System Circuit).
If the reading is within the standard, check the wiring to ECU (see Immobilizer System Circuit)
If the wiring is good, replace the amplifier (see Immobilizer System Parts Replacement in the Electrical System chapter).
The transponder [A] in the ignition key is malfunction.
When the spare key of unregistration is used.
When the ignition key is registered in the registered ECU.
Lower Fairing Installation
Installation is the reverse of removal. Note the following.
When installing the pad [A], align the edge of the pad and
the marking of the fairing [B].
When installing the pad [C], align the edge of the pad and
the fairing [D], and fit the edge of the pad to the boss [E].
Insert the hoo ...
Nozzle Assy Disassembly
Remove the nozzle assy (see Nozzle Assy Removal).
Pull out the secondary fuel injectors [A] from the delivery
pipe assy [B].
NOTE
Do not damage the insertion portions of the injectors
when they are pulled out from the delivery pipe assy.
NOTICE
Never drop the secondary fuel injecto ...
Intake Air Pressure Sensor #2 Output Voltage Inspection
Measure the output voltage at the intake air pressure sensor
#2 in the same way as input voltage inspection, note
the following.
Disconnect the intake air pressure sensor #2 connector
and connect the measuring adapter [A] between these
connectors.
[B] Main Harness
[C] Intake Air Pressu ...