Kawasaki Ninja Service Manual: Appendix

Fluid Pressure Sensor Supply Voltage Inspection (Service Code b 89)

The Fluid Pressure Sensors are built in the KIBS Hydraulic Unit. Therefore the voltage cannot be checked directly. Perform the Pre-Diagnosis Inspection 1 and 2 (see Inquiries to Rider in the B ...

Cable, Wire, and Hose Routing

1. Clamp (Hold the regulator/rectifier lead. Run the lead inside of the installation hole.) 2. Clamp (Bend down the clamp, and hold the main harness and the vacuum hose (equipped models).) ...

Other materials:

Oil Filter Replacement
Drain the engine oil (see Engine Oil Change). Remove the left lower fairing (see Lower Fairing Removal in the Frame chapter). Remove the oil filter [A] with the oil filter wrench [B]. Special Tool - Oil Filter Wrench: 57001-1249 Replace the filter with a new one. Apply grease t ...

Wear Inspection
Remove the left front footpeg bracket bolts. A. Front Footpeg Bracket B. Bolts Remove the bolts and chain cover. A. Bolts B. Chain Cover Stretch the chain taut either by using the chain adjusters, or by hanging a 10 kg (22 lb) weight on the chain. Measure the lengt ...

For Primary Fuel Injectors
Remove the air cleaner housing (see Air Cleaner Housing Removal). Disconnect the injector connector and connect the harness adapter [A] between these connectors as shown in the figure. Main Harness [B] Primary Fuel Injector #1 [C] Special Tool - Measuring Adapter: 57001-1700 ...