Repeat this procedure several times. If the wheel stops of its own accord in various positions, it is well balanced.
If the wheel always stops in one position, adjust the wheel balance (see Balance Adjustment).
Handlebar Removal
Remove:
Steering Damper (see Steering Damper Removal)
Clutch Lever Clamp Bolts [A]
Clutch Lever Assembly [B]
Left Switch Housing [C]
Handlebar Weight [D]
Left Handlebar Grip [E]
Remove:
Front Master Cylinder [A] (see Front Master Cylinder Removal
in the Brakes chapter)
...
Transmission Shaft Assembly
Apply molybdenum disulfide oil solution to the sliding surfaces
of the gears and shafts.
Install the gears and the gear bushings [A] with their holes
[B] aligned.
Replace any circlips removed with new ones.
Install the circlips [A] so that the opening [B] of it is aligned
with ...
Jump starting
If your motorcycle battery is “run
down”, it should be removed and
charged. If this is not practical, a 12
volt booster battery and jumper cables
may be used to start the engine.
DANGER
Battery acid generates hydrogen
gas which is flammable and
explosive under certain conditions.
It i ...