Kawasaki Ninja Service Manual: Balancer

Piston Ring End Gap Inspection

Place the piston ring [A] inside the cylinder (upper crankcase), using the piston to locate the ring squarely in place. Set it close to the bottom of the cylinder, where cylinder wear is low. ...

Balancer Removal

Remove: Engine (see Engine Removal in the Engine Removal/Installation chapter) Oil Pan (see Oil Pan Removal in the Engine Lubrication System chapter) Remove: Balancer Shaft Clamp Lever ...

Other materials:

Oil Cooler Installation
Replace the O-ring [A] with a new one. Apply grease to the new O-ring. Install the water hoses and hose clamps [A] as shown in the figure. Water Hose (About 300 mm, 11.8 in.) [B] Water Hose (About 130 mm, 5.1 in.) [C] Yellow Paint [D] Tighten: Torque - Water Hose Clamp S ...

Special Tools
Inside Circlip Pliers: 57001-143 Oil Seal & Bearing Remover: 57001-1058 Bearing Driver Set: 57001-1129 Jack: 57001-1238 Bearing Remover Head, 15 × 17: 57001-1267 Fork Oil Level Gauge: 57001-1290 Bearing Remover Shaft, 13: 57001-1377 Fork Oil Seal Driver, 43: 57001-15 ...

Fuel Pressure Inspection
NOTE Be sure the battery is fully charged. Remove: Fuel Tank Covers (see Fuel Tank Removal) Fuel Tank Bolts (see Fuel Tank Removal) Primary Fuel Hose (see Fuel Hose Replacement in the Periodic Maintenance chapter) Be sure to place a piece of cloth around the fuel outlet pipe of the ...