The amount of backlash can be changed by turning the balancer shaft which has eccentric journals.
Start the engine and let it idle.
Loosen the clamp bolt [A] and turn the balancer shaft [B] clockwise [C] until the balancer gear makes a whining sound.
Turn the shaft counterclockwise [D] until the balancer gear whining sound disappears and tighten the clamp bolt.
Torque - Balancer Shaft Clamp Bolt: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Coolant Change
WARNINGCoolant can be extremely hot and cause
severe
burns, is toxic and very slippery. Do not remove
the radiator cap or attempt to change the coolant
when the engine is hot; allow it cool completely.
Immediately wipe any spilled coolant from tires,
frame, engine or othe ...
Compression Damping Force Adjuster and Rebound
Damping Force Adjuster Adjustment
The compression damping force adjuster
and the rebound damping force
adjuster are located on top of each front
fork leg.
Turn the adjuster clockwise with a
screwdriver to increase damping
force.
Turn the adjuster counterclockwise
to decrease damping force.
NOTICE
Do not force to t ...
Connecting Rod Big End
Bearing Insert/Crankpin Wear Inspection
Remove the connecting rod big end (see Connecting Rod
Removal).
Cut strips of plastigage to crankpin width. Place a strip
on the crankpin parallel to the crankshaft installed in the
correct position.
Tighten the connecting rod big end nuts to the specified
torque (see Connecting Rod I ...