Kawasaki Ninja Service Manual: Balancer Assemble

Kawasaki Ninja Service Manual / Crankshaft/Transmission / Balancer / Balancer Assemble

Apply molybdenum disulfide oil solution to the ribs of the balancer [A].

Balancer Assemble

Apply molybdenum disulfide oil solution to the ribs of the balancer gear [A].
Check that the rubber dampers [B] are in place.

Face the linked portion [C] to the bottom.

Balancer Assemble

Assemble the balancer weight [A] and the gear [B].

Align the punch mark [C] of the balancer weight and the groove [D] of the gear.

Balancer Assemble

Apply molybdenum disulfide oil solution to the needle bearings [A].
Install the needle bearings and the washers [B].

Face the grooved side of the washer to inside.

Balancer Assemble

Balancer Removal

Remove: Engine (see Engine Removal in the Engine Removal/Installation chapter) Oil Pan (see Oil Pan Removal in the Engine Lubrication System chapter) Remove: Balancer Shaft Clamp Lever ...

Balancer Installation

Position the crankshaft at #2, 3 positions TDC or at #1, 4 positions TDC. Install the balancer assembly as follows. Align the punch mark [A] on the weight and the projection [B] on the cran ...

Other materials:

Starting the Engine
Check that the engine stop switch is in the position. A. Engine Stop Switch B. Starter Button Turn the ignition key to “ON”. Make sure the transmission is in neutral. A. Neutral Indicator Light B. Ignition Switch C. “ON” position NOTE The motorcycle is equipped w ...

ABS Indicator Light (For models equipped with KIBS)
: Normally the ABS indicator light goes on when the ignition switch is turned “ON” and goes off shortly after the motorcycle starts moving. If the ABS is normal, it stays off. If the ABS indicator light shows any of the following, a fault or faults may have taken place in the ABS. You ...

Mode-switching
Depress the S-KTRC button on the left handlebar switch to change the mode. The mode can be changed only when the throttle grip is closed completely. The S-KTRC OFF can be selected only when the motorcycle is at a stop. Changing to mode 1 from S-KTRC OFF is possible while riding. NOTE ...