Before starting to perform an inspection service or carry out a disassembly and reassembly operation on a motorcycle, read the precautions given below. To facilitate actual operations, notes, illustrations, photographs, cautions, and detailed descriptions have been included in each chapter wherever necessary. This section explains the items that require particular attention during the removal and reinstallation or disassembly and reassembly of general parts.
Especially note the following.
Rear Master Cylinder Removal
Unscrew the brake hose banjo bolt [A] and remove the
brake hose (see Brake Hose and Pipe Replacement in
the Periodic Maintenance chapter).
Remove:
Rear Master Cylinder Mounting Bolts [B]
Foot Guard [C]
Screw and Stopper [D]
Bolt [E]
Front Footpeg Bracket Bolts [F]
Cable Guide [G ...
KIBS Servicing Precautions
There are a number of important precautions that should
be followed servicing the KIBS.
This KIBS is designed to be used with a 12 V sealed battery
as its power source. Do not use any other battery
except for a 12 V sealed battery as a power source.
Do not reverse the battery cable connec ...
Connecting Rod Installation
NOTICE
To minimize vibration, the connecting rods should
have the same weight mark.
Big End Cap [A]
Connecting Rod [B]
Weight Mark, Alphabet [C]
Diameter Mark [D] (“” or No Mark)
NOTICE
If the connecting rods, big end bearing inserts, or
crankshaft are replaced with new ones, select ...