Ignition Key Inspection
If the service code 36 appears again, the transponder in the key is malfunction, replace it.
Immobilizer System Circuit
1. ECU
2. Ignition Switch
3. Immobilizer Amplifier
4. Immobilizer Antenna
5. Joint Connector F
6. Joint Connector C
7. Joint Connector D
8. Meter Unit
9. Oil Pressure/Water Temperature/ FI/Immobilizer Warning Indicator LED
10. Fuse Box 1
11. Ignition Fuse 15 A
12. Frame Ground 1
13. Starter Relay
14. Main Fuse 30 A
15. Battery
16. Engine Ground
17. Immobilizer/Kawasaki Diagnostic System Connector
Periodic Maintenance Chart
K : Should be serviced by an authorized Kawasaki dealer.
* : For higher odometer readings, repeat at the frequency interval established
here.
# : Service more frequently when operating in severe conditions: dusty, wet,
muddy,
high speed, or frequent starting/stopping.
(e): Emission Rel ...
Damping Force Adjustment (
ZX1000JC/KC)
To adjust the damping force, turn the damping adjuster
[A] until you feel a click.
The standard adjuster setting is the 18th click from the
1st of the fully clockwise position. If the damping feels too
soft or too stiff, adjust it in accordance with the following
table.
Damping Force Adj ...
Oxygen Sensor Removal (Equipped Models)
Remove:
Fuel Tank (see Fuel Tank Removal in the Fuel System
(DFI) chapter)
Right Lower Fairing (see Lower Fairing Removal in the
Frame chapter)
Disconnect the oxygen sensor lead connector [A].
NOTICE
Do not pull strongly, twist, or bend the oxygen sensor
lead. This may cause the wi ...