In accordance with the Periodic Maintenance Chart, it is very important to check the tightness of the bolts and nuts listed here. Also, check to see that each cotter pin is in place and in good condition. Please ask your authorized Kawasaki dealer for torque values.
1. Clutch Lever Holder Bolts
2. Steering Stem Head Nut
3. Handlebar Clamp Bolts
4. Front Fork Clamp Bolts
5. Brake Lever Mounting Bolts
6. Front Fender Mounting Bolts
7. Engine Mounting Bolts and Nuts
8. Rear Frame Mounting Bolts
9. Brake Disc Mounting Bolts
10. Front Axle Clamp Bolts
11. Front Axle Nut
12. Caliper Mounting Bolts
13. Side Stand Bolt
14. Suspension Likage Tie-Rod Nuts
15. Swingarm Pivot Shaft Nut
16. Footpeg Mounting Bolts
17. Rear Shock Absorber Mounting Bolts
18. Rear Axle Nut
19. Rear Sprocket Nuts
20. Silencer Mounting Bolt
21. Brake Pedal Bolt
22. Exhaust Pipe Mounting Bolt and Nuts
Cylinder (Upper Crankcase) Wear Inspection
Split the crankcase (see Crankcase Splitting).
Remove the pistons (see Piston Removal).
Assemble the cylinder (upper crankcase) [A], the cylinder
head [B] and the cylinder head gasket [C].
Tighten the cylinder head bolts (see Cylinder Head Installation
in the Engine Top End chapter).
...
Check 3-4: Turn Signal Indicator Light (LED) Inspection
Connect the leads in the same circuit as Check 3-2.
Connect the terminal [5] to the battery (+) terminal.
Connect the terminal [6] to the battery (+) terminal.
Check that the turn signal indicator light (LED) [A] goes
on.
If the indicator light does not go on, replace the meter ...
Transmission Assy Installation
Assemble the transmission assy (see Transmission Assy
Assembly).
Be sure that the dowel pins are in position.
Install the transmission assy on the crankcase.
Tighten:
Torque - Transmission Case Bolts: 20 N·m (2.0 kgf·m, 15
ft·lb)
Install:
Shift Shaft (see External Shift Mechani ...