Kawasaki Ninja Service Manual: Brake Disc Wear Inspection

Kawasaki Ninja Service Manual / Brakes / Brake Disc / Brake Disc Wear Inspection

If the disc has worn past the service limit, replace it.

Measuring Area [B]

Brake Disc Wear Inspection


Brake Disc Thickness Standard:

Front 5.3 5.7 mm (0.21
0.22 in.)


Rear 4.8 5.2 mm (0.19
0.20 in.)


Service Limit:

Front 5.0 mm (0.20 in.)

Rear 4.5 mm (0.18 in.)

Brake Disc Installation
Install the brake disc on the wheel so that the marked side [A] faces out. Front Brake Discs [B] Rear Brake Disc [C] Apply a non-permanent locking agent to the threads of the brake disc ...

Brake Disc Warp Inspection
Raise the wheel off the ground with the jack. Special Tools - Jack: 57001-1238 Jack Attachment: 57001-1608 For front disc inspection, turn the handlebar fully to one side. Set up a dial ...

Other materials:

Serial number locations
The engine and frame serial numbers are used to register the motorcycle. They are the only means of identifying your particular machine from others of the same model type. These serial numbers may be needed by your dealer when ordering parts. In the event of theft, the investigating authoriti ...

Engine Oil Flow Chart
1. Oil Screen 2. Oil Pump 3. Oil Pressure Relief Valve 4. Oil Filter 5. Oil Pipe 6. Oil Cooler 7. Balancer Oil Passage 8. Main Oil Passage 9. Crankshaft Oil Passage 10. Oil Pressure Switch 11. Camshaft Oil Passages 12. Drive Shaft Oil Passage 13. Output Shaft Oil Passage 14. Starter ...

Brake Fluid Leak (Brake Hose and Pipe) Inspection
For KIBS equipped models, remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Apply the brake lever or pedal and inspect the brake fluid leak from the brake hoses [A], pipes (KIBS equipped models) [B] and fittings [C]. If the brake fluid leaked from any posit ...