NOTE
The procedure to change the front brake fluid is as follows.
Changing the rear brake fluid is the same as for the front brake.
Level the brake fluid reservoir.
Repeat this operation until fresh brake fluid comes out from the plastic hose or the color of the fluid changes.
1. Open the bleed valve [A].
2. Apply the brake and hold it [B].
3. Close the bleed valve [C].
4. Release the brake [D].
NOTE
Remove the clear plastic hose.
Install the diaphragm and reservoir cap.
Follow the procedure below to install the front/rear brake fluid reservoir cap correctly.
Torque - Front Brake Reservoir Cap Stopper Screw: 1.2 N·m (0.12 kgf·m, 11 in·lb)
Torque - Bleed Valves: 7.8 N·m (0.80 kgf·m, 69 in·lb)
If necessary, bleed the air from the lines.
Headlight Beam
NOTE
Do not turn the bolts because the reflector
in the headlight comes off.
A. Bolts
The left and right adjusters on the
headlight can move the direction of
the headlight beam to up, down, left
and right by turning each adjuster itself
as the below table.
A. Left Adjuster
...
Compression Damping Force Adjustment
To adjust the compression damping force, turn the compression
damping adjuster [A].
The standard adjuster setting is the 4 1/2 turns out from
the fully clockwise position.
WARNINGIf both adjusters are not adjusted
equally, handling
may be impaired and a hazardous condition ma ...
Drive Chain Removal/Installation
NOTE
Since the drive chain is installed through the swingarm,
The chain can not be removed other than by cutting it.
Prepare the new link pin, link plate, grease seals, and
tools for rejoining the chain.
Remove:
Bolts [A]
Front Footpeg Bracket [B]
Remove:
Bolts [A]
Chain Cover [B]
...