The high pressure inside the brake line can cause fluid to leak [A] or the hose to burst if the line is not properly maintained.
Bend and twist the rubber hose while examining it.
Torque - Brake Hose Banjo Bolts: 25 N·m (2.5 kgf·m, 18 ft·lb)
If any brake hose routing is incorrect, run the brake hose according to Cable, Wire, and Hose Routing section in the Appendix chapter.
Transmission Shaft Assembly
Apply molybdenum disulfide oil solution to the sliding surfaces
of the gears and shafts.
Install the gears and the gear bushings [A] with their holes
[B] aligned.
Replace any circlips removed with new ones.
Install the circlips [A] so that the opening [B] of it is aligned
with ...
City Light (LED) Removal/Installation
Remove:
Upper Fairing Assembly (see Upper Faring Assembly
Removal in the Frame chapter)
Headlight (see Headlight Removal)
Remove the screws [A], and take the city light [B] off the
upper fairing assembly.
Installation is the reverse of removal. Note the following.
When inst ...
System Components
1. FI ECU
The FI ECU analyzes the motorcycle conditions based
on the signals from the front/rear wheel rotation sensors
and FI sensors (such as the crankshaft sensor and main
throttle sensor), and controls engine power by reducing the
number of ignition and retarding the ignition timing. The
m ...