Kawasaki Ninja Service Manual: Brake Pedal Position Inspection

Brake Lever Position Adjustment

The brake lever adjuster has 6 positions so that the brake lever position can be adjusted to suit the operator’s hand. Push the lever forward and turn the adjuster [A] to align the number wit ...

Brake Pedal Position Adjustment

NOTE Usually it is not necessary to adjust the pedal position, but always adjust it when push rod locknut has been loosened. Loosen the locknut [A] and turn the push rod with the hex head [B] ...

Other materials:

Transmission Assy Removal
Remove: Engine Sprocket (see Engine Sprocket Removal in the Final Drive chapter) Gear Position Switch (see Gear Position Switch Removal in the Electrical System chapter) Collar [A] O-ring [B] Remove: Clutch (see Clutch Removal in the Clutch chapter) Shift Shaft Assembly ...

Rear Wheel Rotation Sensor Signal Abnormal (Service Code b 44)
Measure the air gap between the rear wheel rotation sensor and sensor rotor. Thickness Gauge [A] Air Gap Standard: 0.4 1.6 mm (0.02 0.06 in.) If the measurement is not the standard, check each part for deformation and looseness and correct accordingly. If the measurement is the sta ...

Charging Voltage Inspection
Check the battery condition (see Charging Condition Inspection). Warm up the engine to obtain actual alternator operating conditions. Remove the front seat (see Front Seat Removal in the Frame chapter). Check that the ignition switch is turned off, and connect the hand tester [A] to t ...