Kawasaki Ninja Service Manual: Brakes

Rear Sprocket Warp Inspection

Raise the rear wheel off the ground with the stand so that it will turn freely. Set a dial gauge [A] against the rear sprocket [B] near the teeth as shown in the figure, and rotate [C] the re ...

Exploded View

13. Front Wheel Rotation Sensor B: Apply brake fluid. L: Apply a non-permanent locking agent. R: Replacement Parts S: Follow the specified tightening sequence. Si: Apply silicone gr ...

Other materials:

Immobilizer Amplifier Replacement
Remove the upper fairing assembly (see Upper Fairing Assembly Removal in the Frame chapter). Disconnect the connector [A]. Pull out the immobilizer amplifier [B] together with the rubber protector [C] from the air intake duct [D]. ECU Replacement Refer to the ECU Removal/Instal ...

Engine Oil Change
Situate the motorcycle so that it is vertical after warming up the engine. Remove the engine oil drain bolt [A] to drain the oil. The oil in the oil filter can be drained by removing the filter (see Oil Filter Replacement). Replace the drain bolt gasket [B] with a new one. Tighten t ...

Starter Clutch Removal
Remove: Torque Limiter (see Torque Limiter Removal) Transmission Assy (see Transmission Assy Removal) Starter Clutch Shaft Holder Bolt [A] Starter Clutch Shaft Bolt [B] Starter Clutch Shaft Holder [C] Remove the starter clutch shaft [A] using a suitable M8 bolt [B]. Take ...