Right-hand End Cover and Negative Brushes [A] Terminal Bolt and Positive Brushes [B]
Special Tool - Hand Tester: 57001-1394
If there is not close to zero ohms, the brush lead has an open. Replace the brush plate assy.
Upper Crankcase Assembly
When installing the breather plate, replace the gasket [A]
with a new one.
Apply a non-permanent locking agent to the threads of
the bolts [A] and tighten them.
Torque - Breather Plate Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Install the fitting [A] until it is bottomed ...
Compression Damping Force Adjustment
The compression damping force adjusters
for high and low speeds are located
on the gas reservoir at the left
side of the rear shock absorber.
A. High Speed Adjuster
B. Low Speed Adjuster
NOTE
Turning the high speed adjuster has
the low speed adjuster turning. Although
the low speed adju ...
Water Temperature Sensor Output Voltage Inspection
NOTE
Be sure the battery is fully charged.
Turn the ignition switch to OFF.
Remove the throttle body assy (see Throttle Body Assy
Removal in the Fuel System (DFI) chapter).
Disconnect the water temperature sensor connector and
connect the measuring adapter [A] between these connectors
...