Kawasaki Ninja Service Manual: Cable Installation

Kawasaki Ninja Service Manual / Clutch / Clutch Lever and Cable / Cable Installation

Run the clutch cable correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter).
Adjust the clutch cable (see Clutch Operation Inspection in the Periodic Maintenance chapter).
Install the removed parts (see appropriate chapters).

Cable Lubrication

Refer to the Chassis Parts Lubrication in the Periodic Maintenance chapter.

Cable Removal

Remove: Air Cleaner Housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter) Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Loosen the nuts [A], an ...

Clutch Lever Installation

Install the clutch lever so that the mating surface [A] of the clutch lever clamp is aligned with the punch mark [B] of the handlebar. Tighten the upper clamp bolt first, and then the lower ...

Other materials:

Idle Speed Control Valve Actuator Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Disconnect the idle speed control valve actuator connector and connect a suitable measuring leads [A] between these connectors as shown in the figure. Main Harness [B] Idle Speed Control Valve Actua ...

Piston Removal
Remove: Crankshaft (see Crankshaft Removal) Remove the piston together with the connecting rod to the cylinder head side. NOTICE Discard the connecting rod bolts and nuts. To prevent damage to the crankpin surfaces, do not allow the connecting rod bolts to bump against the crankpins. ...

Exploded View
25. “1T” marked side faces up. 26. “T2” marked side faces up. 27. Hollow mark faces exhaust side. G: Apply grease. L: Apply a non-permanent locking agent. LG: Apply liquid gasket. M: Apply molybdenum disulfide grease. MO: Apply molybdenum disulfide oil solution. ...