Kawasaki Ninja Service Manual: Camshaft Chain Tensioner

Cylinder Head Cover Installation

Replace the cylinder head cover gasket [A] with a new one Using a high flash-point solvent, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clean ...

Camshaft Chain Tensioner Removal

NOTICE This is a non-return type camshaft chain tensioner. The push rod does not return to its original position once it moves out to take up camshaft chain slack. Observe all the rules listed ...

Other materials:

Drive Chain Slack Inspection
NOTE Check the slack with the motorcycle setting on its sidestand. Clean the chain if it is dirty, and lubricate it if it appears dry. Check the wheel alignment (see Wheel Alignment Inspection). Rotate the rear wheel to find the position where the chain is tightest. Measure the ver ...

Model Identification
ZX1000JB (US and CA Models) Left Side View ZX1000JB (US and CA Models) Right Side View ZX1000JB (EUR Models) Left Side View ZX1000JB (EUR Models) Right Side View ZX1000KB (US and CA Models) Left Side View ZX1000KB (US and CA Models) Right Side View ZX1000KB (EUR Models) ...

Water Pump Housing Disassembly
NOTICE Do not damage the hole wall of the water pump housing. Insert a bar [A] into the pump housing [B], and hammer evenly around the circumference of the mechanical seal bottom [C]. Take the oil seal [A] out of the housing [B] with a hook [C]. ...