Kawasaki Ninja

Kawasaki Ninja Service Manual: Canister Inspection

Kawasaki Ninja Service Manual / Fuel System (DFI) / Evaporative Emission Control System (CAL and SEA-B1 Models) / Canister Inspection

Canister Inspection


1. Green Hoses (Purge)

2. Fittings

3. Canister

4. White Hose (Vacuum)

5. Throttle Body Assy

6. Fuel Tank

7.Red Hose (Return)

8. Blue Hose (Breather)

9. Bracket (for Separator)

10. Separator

11. Blue Hoses (Breather)

12. Bracket (for Canister)

Separator Operation Test
WARNINGGasoline is extremely flammable and can be explosive under certain conditions. Turn the ignition switch OFF. Do not smoke. Make sure the area is well-ventilated and free fro ...

Cooling System
...

Other materials:

Charging Voltage Inspection
Check the battery condition (see Charging Condition Inspection). Warm up the engine to obtain actual alternator operating conditions. Remove the front seat (see Front Seat Removal in the Frame chapter). Check that the ignition switch is turned off, and connect the hand tester [A] to t ...

General Lubrication
Lubricate the points shown below, with either motor oil or regular grease, in accordance with the Periodic Maintenance Chart or whenever the vehicle has been operated under wet or rainy conditions. Before lubricating each part, clean off any rusty spots with rust remover and wipe off any g ...

IC Igniter Inspection
The IC igniter is built in the ECU [A]. Refer to the following items. Interlock Operation Inspection (see Interlock Operation Inspection) Ignition System Troubleshooting (see Ignition System section) ECU Power Supply Inspection (see ECU Power Supply Inspection in the Fuel System (D ...