Battery charging condition can be checked by measuring battery terminal voltage with a digital voltmeter [A].
NOTICE
Be sure to disconnect the negative (–) cable first.
NOTE
Measure with a digital voltmeter which can be read one decimal place voltage.
If the reading is 12.8 V or more, refresh charge is not required, however, if the read is below the 12.8 V, refresh charge is required.
Battery Terminal Voltage Standard: 12.8 V or more
Terminal Voltage (V) [A] Battery Charge Rate (%) [B] Good [C] Refresh charge is required [D]
S-KTRC Mode Indicator
This indicator shows the selected
S-KTRC mode. For more detailed information
about the S-KTRC mode,
see Sport-Kawasaki TRaction Control
(S-KTRC) section in the How to Ride
the Motorcycle chapter
A. S-KTRC Mode Indicator
NOTE
When the all S-KTRC mode indicators
go off, the battery voltag ...
Throttle Control System Inspection
Check the throttle grip free play [A].
If the free play is incorrect, adjust the throttle cables.
Throttle Grip Free Play
Standard: 2 3 mm (0.08
0.12 in.)
Check that the throttle grip [B] moves smoothly from full
open to close, and the throttle closes quickly and completely
by the ...
Shift Pedal Installation
Install the rubber damper to the shift pedal.
Turn the chamfered side to inside.
Assemble:
Shift Lever [A] and Locknut [B] (Left-hand Thread)
Shift Pedal [C] and Locknut [D]
Tie-Rod [E]
Turn the grooved end [F] of the tie-rod to the shift lever.
Apply grease to the sliding ...