Kawasaki Ninja Service Manual: Check 2-2: Fuel Level Warning Inspection

Kawasaki Ninja Service Manual / Electrical System / Meter, Gauge, Indicator Unit / Meter System Inspection / Check 2-2: Fuel Level Warning Inspection

Remove: Fuel Tank (see Fuel Tank Removal in the Fuel System (DFI) chapter)
Connect the resistor(s) [A] (about 50 to 100 Ω) between the fuel pump connector terminal [B] of the main harness side and the battery negative (–) terminal [C] as shown.

Check 2-2: Fuel Level Warning Inspection

Turn the ignition switch to ON.
After about 5 seconds, the meter indicate the following.

For ZX1000J Model

Fuel Level Warning Indicator Light (LED) [A] goes on “FUEL” blinks [B]

For ZX1000K Model

Warning Indicator Light (Yellow LED) [C] goes on FUEL Warning Symbol goes on “FUEL” blinks [B]

If the display and indicator light (LED) function does not work, replace the meter unit.

Check 2-2: Fuel Level Warning Inspection

Check 2-1: Speedometer Inspection

Using the suitable stand, raise the rear wheel off the ground. Rotate the rear wheel by hand or start the engine. Check that the display changes speedometer. If the display function does n ...

Check 2-3: Intake Air Temperature Inspection

Disconnect the intake air temperature sensor connector [A] (see Intake Air Temperature Sensor Removal in the Self-Diagnosis System chapter). Connect the variable rheostat [B] to the R/BK lead ...

Other materials:

Torque and Locking Agent
The following tables list the tightening torque for the major fasteners requiring use of a non-permanent locking agent or silicone sealant etc. Letters used in the “Remarks” column mean: AL: Tighten the two clamp bolts alternately two times to ensure even tightening torque. G: Apply ...

Pressure Testing
Remove: Upper Fairing Assembly (see Upper Fairing Assembly Removal in the Frame chapter) Radiator Cap [A] Remove the radiator cap in two steps. First turn the cap counterclockwise to the first stop. Then push and turn it further in the same direction and remove the cap. Install the ...

Meter Unit Circuit (ZX1000J Model)
1. Ignition Switch 2. Joint Connector F 3. Stop Watch Button 4. Oil Pressure Switch 5. Crankshaft Sensor 6. Water Temperature Sensor 7. Gear Position Switch 8. Intake Air Temperature Sensor 9. ESD ECU (ZX1000JD/KD) 10. ECU 11. Rear Wheel Rotation Sensor 12. Engine Ground 13. Battery ...