The display range is –20 ∼ 140°C (–4 ∼ 284°F).
If the temperature is out of the range, the indication fixes the minimum value or maximum value.
When the speed is 20 km/h (12 mph) or less and rising the temperature, the indication fixes the value of just before the indication.
If the display function does not work, check the wiring (see Meter Unit Circuit).
If the wiring is good, replace the meter assembly.
Oil Pump Drive Gear Installation
Install is the reverse of removal. Note the following.
First, engage the oil pump chain [A] to the gears, and then
install the oil pump drive gear [B].
Turn the “OUT” mark [C] to outside.
Apply a non-permanent locking agent to the oil pump drive
chain guide bolt and the oil pump drive ...
Rear Master Cylinder Installation
Replace the washers that are on each side of hose fitting
with new ones.
Install the brake hose [A].
Touch the brake hose to the stopper [B] of the rear master
cylinder.
Tighten:
Torque - Brake Hose Banjo Bolt: 25 N·m (2.5 kgf·m, 18 ft·lb)
Install the master cylinder, the brack ...
Oil Level Inspection
If the oil has just been changed, start
the engine and run it for severalminutes
at idle speed. This fills the oil
filter with oil. Stop the engine, then
wait several minutes until the oil settles.
NOTICE
Racing the engine before the oil
reaches every part can cause engine
seizure.
...