Special Tool - Hand Tester: 57001-1394
CAN Communication Line Resistance (at Meter Unit) Standard: 122 126 Ω
If the tester reading is not specified, replace the meter unit.
Check 3-2: Meter Unit Power Supply Check
Connect the battery positive (+) terminal to the terminal [1] [9].
Connect the battery negative (–) terminal to the terminal [3].
The all LCD segments [A] appear for 3 seconds.
The tachometer (LED) [B] blinks 3 times.
For ZX1000J model, the fuel level warning indicator light (LED) [C] and warning indicator light (Red LED) [D] go on.
For ZX1000K model, the ABS indicator light (LED) [C] and warning indicator light (Red LED) [D] go on.
The following items blinks.
Power Mode Indicator [E] S-KTRC Mode indicator [F] “FUEL” Segment [G] Fuel Level Warning Symbol [H] (ZX1000K model)
Starter Relay Inspection
Remove the front seat (see Front Seat Removal in the
Frame chapter).
Remove the battery negative (–) cable from the battery
negative (–) terminal (see Battery Removal).
Take the starter relay [A] off the rear fender.
Remove the cover [B].
Remove:
Starter Motor Cable [A] ...
Water Pump Housing Disassembly
NOTICE
Do not damage the hole wall of the water pump
housing.
Insert a bar [A] into the pump housing [B], and hammer
evenly around the circumference of the mechanical seal
bottom [C].
Take the oil seal [A] out of the housing [B] with a hook [C].
...
Engine No. ZXT00JE003023
1. Heat Insulation Rubber Plate
2. For Air Switching Valve Hoses (Place the air switching valve above the
rubber plate.)
3. For Stick Coils
4. For Throttle Body Assy Holder #2 and #3
5. For Water Temperature Sensor
6. Insert the tab into the slot.
7. For Throttle Body Assy Holder #4
8. ...