When installing the pad [A], install it as shown in the figure.
8 mm (0.3 in.) [B]
Water Temperature Sensor Inspection
Remove the water temperature sensor (see Water Temperature
Sensor Removal/Installation in the Fuel System
(DFI) chapter).
Suspend the sensor [A] in a container of coolant so that
the temperature-sensing projection [C] is submerged.
Suspend an accurate thermometer [B] with temperature
...
Brake Hose and Pipe Damage and Installation Condition Inspection
Inspect the brake hoses, pipes and fittings for deterioration,
cracks and signs of leakage.
The high pressure inside the brake line can cause fluid to
leak [A] or the hose to burst if the line is not properly maintained.
Bend and twist the rubber hose while examining
it.
Replace the ...
Precautions
There are a number of important precautions that are
musts when servicing electrical systems. Learn and observe
all the rules below.
Do not reverse the battery cable connections. This will
burn out the diodes on the electrical parts.
Always check battery condition before condemning other
...