Kawasaki Ninja Service Manual: Clutch Cover Disassembly

Release Shaft Installation

Apply grease to the oil seal lips on the upper ridge of the clutch cover. Apply engine oil to the needle bearings in the hole of the clutch cover. Applymolybdenum disulfide grease to the pu ...

Clutch Cover Assembly

Replace the needle bearings and oil seal with new ones. NOTE Install the needle bearings so that the manufacture’s mark face out. Install the needle bearings [A] and oil seal [B] pos ...

Other materials:

Compression Damping Force Adjuster and Rebound Damping Force Adjuster Adjustment
The compression damping force adjuster and the rebound damping force adjuster are located on top of each front fork leg. Turn the adjuster clockwise with a screwdriver to increase damping force. Turn the adjuster counterclockwise to decrease damping force. NOTICE Do not force to t ...

Wheel Bearing Damage Inspection
Raise the front wheel off the ground with the jack (see Front Wheel Removal in the Wheels/Tires chapter). Special Tools - Jack: 57001-1238 Jack Attachment: 57001-1608 Turn the handlebar all the way to the right or left. Inspect the roughness of the front wheel bearing by moving [A] ...

Air Cleaner Housing Assembly
Install the ducts to the air cleaner housing. Fit the projections [A] of the duct into the slits [B] on the air cleaner housing. Tighten the screws [A]. Torque - Air Cleaner Housing Duct Screws: 1.1 N·m (0.11 kgf·m, 10 in·lb) Install: Air Cleaner Gasket [A] Duct [B] ...