Kawasaki Ninja Service Manual: Clutch Cover Installation

Kawasaki Ninja Service Manual / Clutch / Clutch Cover / Clutch Cover Installation

Sealant - Liquid Gasket, TB1211F: 92104-0004

Clutch Cover Installation


Clutch Cover Installation


Torque - Clutch Cover Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)

Tighten the bolt (L = 45 mm, 1.8 in.) [A] together with the clutch cable bracket [B] as shown in the figure.

Clutch Cover Installation


Clutch Cover Removal
Remove: Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Clutch Cable Lower End (see Cable Removal) Clutch Cover Bolts [A] Turn the release lever [A] countercl ...

Release Shaft Removal
NOTICE Do not remove the clutch release lever and shaft assembly unless it is absolutely necessary. If removed, the oil seal replacement may be required. Remove the clutch cover (see Clutch ...

Other materials:

Meter Unit Circuit (ZX1000J Model)
1. Ignition Switch 2. Joint Connector F 3. Stop Watch Button 4. Oil Pressure Switch 5. Crankshaft Sensor 6. Water Temperature Sensor 7. Gear Position Switch 8. Intake Air Temperature Sensor 9. ESD ECU (ZX1000JD/KD) 10. ECU 11. Rear Wheel Rotation Sensor 12. Engine Ground 13. Battery ...

Upper Fairing Assembly Removal
Remove: Lower Fairings (see Lower Fairing Removal) Center Inner Fairing (see Center Inner Fairing Removal) Upper Inner Fairings (see Upper Inner Fairing Removal) Windshield (see Windshield Removal) Disconnect the front turn signal light lead connector [A] (both sides). Remove the bo ...

Brake Fluid Change
NOTE The procedure to change the front brake fluid is as follows. Changing the rear brake fluid is the same as for the front brake. Level the brake fluid reservoir. Remove: Screw [A] Stopper [B] Front Brake Reservoir Cap [C] Diaphragm Plate Diaphragm Remove the rubb ...