If they are badly worn or if there are groove cuts where the tangs hit, replace the housing. Also, replace the friction plates if their tangs are damaged.
General Lubrication
Lubricate the points shown below,
with either motor oil or regular grease,
in accordance with the Periodic Maintenance
Chart or whenever the vehicle
has been operated under wet or rainy
conditions.
Before lubricating each part, clean off
any rusty spots with rust remover and
wipe off any g ...
Intake Air Pressure Sensor #1 Installation
NOTE
The intake air pressure sensor #1 is the same part as
the intake air pressure sensor #2.
Installation is basically the reverse of removal.
Position the intake air pressure sensor #1 [A] between the
projections [B] on the rubber damper.
Install the rubber damper [A] on the bracket ...
Parts Removal/Installation
WARNINGGasoline is extremely flammable and can be
explosive
under certain conditions. Turn the ignition
switch OFF. Do not smoke. Make sure the area is
well-ventilated and free from any source of flame
or sparks; this includes any appliance with a pilot
light.
NOTICE
...