If any plate is warped over the service limit, replace it with a new one.
Friction and Steel Plate Warp
Standard: 0.15 mm (0.0059 in.) or less
Service Limit: 0.3 mm (0.012 in.)
Master Cylinder Inspection (Visual Inspection)
Remove the master cylinders (see Front/Rear Master
Cylinder Removal).
Disassemble the front and rear master cylinders (see
Master Cylinder Rubber Parts Replacement in the Periodic
Maintenance chapter).
Check that there are no scratches, rust or pitting on the
inner wall [A] of each ma ...
Kawasaki Clean Air System
The Kawasaki Clean Air System
(KCA) is a secondary air suction system
that helps the exhaust gases to
burn more completely. When the spent
fuel charge is released into the exhaust
system, it is still hot enough to
burn. The KCA System allows extra
air into the exhaust system so that the
spen ...
US, CA and CAL Models
1. Hold the water hose [A]. Insert the tab into the slot.
2. Hold the water hose [B]. Insert the tab into the slot.
3. Water Hose Fitting on Cylinder Head
4. Heat Insulation Rubber Plate
5. Run the crankshaft sensor lead and the oil pressure switch lead into the
slot, and hook the slot
on ...