NOTE
Do not use emery or sand paper on the commutator.
Replace the starter motor with a new one if there is any damage or wear.
Replace the starter motor with a new one if discoloration is noticed.
Regulator/Rectifier Inspection
Remove:
Upper Fairing Assembly (see Upper Fairing Assembly
Removal in the Frame chapter)
Right Inner Fairing (see Inner Fairing Removal in the
Frame chapter)
Bolts [A]
Regulator/Rectifier [B]
Set the hand tester to the × 1 kΩ range and make the
measurements show ...
DFI Parts Location
Main Throttle Sensor [A]
Subthrottle Sensor [B]
Idle Speed Control Valve Actuator [C]
Subthrottle Valve Actuator [D]
Intake Air Pressure Sensor #2 [E]
Stick Coils #1, #2, #3, #4 [F]
Air Switching Valve [G]
Intake Air Pressure Sensor #1 [H]
Water Temperature Sensor [A]
Primary Fuel Injec ...
Balancer Installation
Position the crankshaft at #2, 3 positions TDC or at #1, 4
positions TDC.
Install the balancer assembly as follows.
Align the punch mark [A] on the weight and the projection
[B] on the crankcase.
Engage the balancer gear and the crankshaft gear.
Insert the balancer shaft until it is bot ...