Kawasaki Ninja Owners Manual: Coolant Level Inspection

Kawasaki Ninja Owners Manual / Maintenance and adjustment / Cooling System / Coolant / Coolant Level Inspection

Situate the motorcycle so that it is perpendicular to the ground.
Check the coolant level through the coolant level gauge on the reserve tank located to the left of the engine.

The coolant level should be between the “F” (Full) and “L” (Low) level lines.

A. Reserve Tank

B. “F” (Full) Level Line

C. “L” (Low) Level Line

NOTE

Check the level when the engine is cold (room or atmospheric temperature).
If the amount of coolant is insufficient, add coolant into the reserve tank.
Remove the cap from the reserve tank and add coolant through the filler opening to the “F” (Full) level line.

Information for Coolant

To protect the cooling system (consisting of the aluminum engine and radiator) from rust and corrosion, the use of corrosion and rust inhibitor chemicals in the coolant is essential. If coolant c ...

Coolant Filling

Remove the bolts and quick rivets. Detach the tabs and remove the right fairing and cover. A. Bolts B. Quick Rivet C. Large Quick Rivet D. Tabs E. Right Fairing and Cover NOTE T ...

Other materials:

Drive Chain Lubrication Condition Inspection
If a special lubricant is not available, a heavy oil such as SAE 90 is preferred to a lighter oil because it will stay on the chain longer and provide better lubrication. If the chain appears especially dirty, clean it before lubrication. NOTICE The O-rings between the side plates seal ...

Lighting System
This motorcycle adopt the daylight system and have a headlight relay in the relay box. The headlight does not go on when the ignition switch and the engine stop switch are first turned on. The headlight comes on after the starter button is released and stays on until the ignition switch is turn ...

Alternator Inspection
There are three types of alternator failures: short, open (wire burned out), or loss in rotor magnetism. A short or open in one of the coil wires will result in either a low output, or no output at all. A loss in rotor magnetism, which may be caused by dropping or hitting the alternator, by leav ...