Kawasaki Ninja Service Manual: Coolant Reserve Tank Installation

Kawasaki Ninja Service Manual / Cooling System / Coolant / Coolant Reserve Tank Installation

Install the following to the coolant reserve tank [A].

Pad [B] Gasket [C] Cap [D] Collar [E]
Install the coolant reserve tank and tighten the bolt [F].
Run the hoses correctly (see Cable,Wire, and Hose Routing section in the Appendix chapter).
Fill the coolant reserve tank with coolant (see Coolant Change in the Periodic Maintenance chapter).

Coolant Reserve Tank Installation

Coolant Reserve Tank Removal

Remove: Upper Fairing Assembly (see Upper Fairing Assembly Removal in the Frame chapter) Bolt [A] Cap [B] Pour the coolant into a container. Remove: Radiator Overflow Hose [C] (Discon ...

Water Pump

Water Pump Removal Refer to the Oil Pump Removal in the Engine Lubrication System chapter. Water Pump Installation Refer to the Oil Pump Installation in the Engine Lubrication System chapter. ...

Other materials:

Connecting Rod Bend Inspection
Remove the connecting rod big end bearing inserts, and reinstall the connecting rod big end cap. Select an arbor [A] of the same diameter as the connecting rod big end, and insert the arbor through the connecting rod big end. Select an arbor of the same diameter as the piston pin and ...

KIBS Hydraulic Unit Terminal Names
1. Ground: BK 2. CAN Communication Line (High): GY/BL 3. Front Wheel Rotation Sensor Signal Input: Y 4. Power Supply: BR/W 5. KIBS Kawasaki Self-Daignosis System Terminal: P 6. Front and Rear Brake Light Switch Signal: BL/R 7. Unused 8. Front Wheel Rotation Sensor Signal Output: G/Y 9. P ...

Current Mileage
This display mode shows the current mileage by numerical value. The current mileage display is renewed every 4 seconds. A. Current Mileage B. “km/L” NOTE The display unit modes can be changed, refer to the “Unit Setting” item in this section. The numerical value shows “ ...