Kawasaki Ninja Service Manual: Coupling Damper Inspection

Coupling Bearing Inspection

Since the coupling bearing is made to extremely close tolerances, the clearance can not normally be measured. NOTE It is not necessary to remove the coupling bearing for inspection. If the bea ...

Sprocket Wear Inspection

Visually inspect the engine and rear sprocket teeth for wear and damage. If the teeth are worn as illustrated, replace the sprocket, and inspect the drive chain wear (see Drive Chain Wear In ...

Other materials:

Canister Inspection
Refer to the Evaporative Emission Control System Inspection (CAL and SEA-B1 Models) in the Periodic Maintenance chapter. 1. Green Hoses (Purge) 2. Fittings 3. Canister 4. White Hose (Vacuum) 5. Throttle Body Assy 6. Fuel Tank 7.Red Hose (Return) 8. Blue Hose (Breather) 9. Brack ...

Stick Coil Installation
Apply a thin coat of grease [A] to the stick coils for easy installation. Insert the stick coils so that the coil heads align with the lines [B] on the cylinder head cover. NOTICE Do not tap the coil head while installing the coil. After installation, be sure the stick coils are ...

For Primary Fuel Injectors
Remove the air cleaner housing (see Air Cleaner Housing Removal). Disconnect the injector connector and connect the harness adapter [A] between these connectors as shown in the figure. Main Harness [B] Primary Fuel Injector #1 [C] Special Tool - Measuring Adapter: 57001-1700 ...