Kawasaki Ninja Service Manual: Crankshaft and Connecting Rods

Kawasaki Ninja Service Manual / Crankshaft/Transmission / Crankshaft and Connecting Rods

Crankcase Halves Assembly
Install: Crankshaft (see Crankshaft Installation) Connecting Rods (see Connecting Rod Installation) Using a cleaning fluid, clean off any oil or dirt on the mating surface of the crankcase ...

Crankshaft Removal
Split the crankcase (see Crankcase Splitting). Remove: Connecting Rod Big End Nuts [A] Connecting Rod Big End Caps [B] NOTE Mark and record the locations of the connecting rods and their ...

Other materials:

Piston Wear Inspection
Measure the outside diameter [A] of each piston 5 mm (0.20 in.) [B] up from the bottom of the piston at a right angle to the direction of the piston pin. If the measurement is under service limit, replace the piston. Piston Diameter Standard: 75.959 75.974 mm (2.9905 2.9911 in.) ...

Wheel Rotation Sensor Rotor Inspection
Remove: Wheels (see Front/Rear Wheel Removal in the Wheels/Tires chapter) Brake Disc Mounting Bolts [A] Sensor Rotor [B] Front Wheel [C] Rear Wheel [D] Visually inspect the wheel rotation sensor rotor. If the rotor is deformed or damaged (chipped teeth [A]), replace the ...

Brakes
Brake Wear Inspection Inspect the brakes for wear. For each front and rear disc brake caliper, if the thickness of either pad is less than 1 mm (0.04 in.), replace both pads in the caliper as a set. Pad replacement should be done by an authorized Kawasaki dealer. A. Lining Thickness B. ...