Kawasaki Ninja Service Manual: Crankshaft/Connecting Rod Cleaning

Kawasaki Ninja Service Manual / Crankshaft/Transmission / Crankshaft and Connecting Rods / Crankshaft/Connecting Rod Cleaning

After removing the connecting rods from the crankshaft, clean them with a high flash-point solvent.
Blow the crankshaft oil passages with compressed air to remove any foreign particles or residue that may have accumulated in the passages.

Connecting Rod Installation

NOTICE To minimize vibration, the connecting rods should have the same weight mark. Big End Cap [A] Connecting Rod [B] Weight Mark, Alphabet [C] Diameter Mark [D] (“” or No Mark) NOTICE ...

Connecting Rod Bend Inspection

Remove the connecting rod big end bearing inserts, and reinstall the connecting rod big end cap. Select an arbor [A] of the same diameter as the connecting rod big end, and insert the arbor t ...

Other materials:

Oil and/or Oil Filter Change
To change the engine oil and replace oil filter, the engine oil drain bolt and oil filter must be removed. The oil change and oil filter replacement should be done by an authorized Kawasaki dealer. A. Engine Oil Drain Bolt A. Oil Filter WARNINGEngine oil is a toxic s ...

Trip Meters
The trip meter has two meters which distinguished between the “TRIP A” and “TRIP B”. The trip meter shows the distance in kilometers or miles traveled since it was last reset to zero. TRIP A: 0.0 9999.9 TRIP B: 0.0 9999.9 A. Trip Meter B. “TRIP A” To reset the trip meter: ...

DFI Servicing Precautions
There are a number of important precautions that should be followed servicing the DFI system. This DFI system is designed to be used with a 12 V sealed battery as its power source. Do not use any other battery except for a 12 V sealed battery as a power source. Do not reverse the battery ...