Kawasaki Ninja Service Manual: Crankshaft Sensor Installation

Kawasaki Ninja Service Manual / Electrical System / Ignition System / Crankshaft Sensor Installation

Apply a non-permanent locking agent to the crankshaft sensor bolts [A].
Tighten: Torque - Crankshaft Sensor Bolts: 5.9 N·m (0.60 kgf·m, 52 in·lb)
Using a high flash-point solvent, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clean cloth.
Apply silicone sealant to the circumference of the crankshaft sensor lead grommet [B], and fit the grommet into the notch of the crankshaft sensor cover securely.

Sealant - Liquid Gasket, TB1211F: 92104-0004

Crankshaft Sensor Installation

Using a high flash-point solvent, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clean cloth.
Apply silicone sealant to the crankcase mating surface [A] on the front and rear sides of the cover mount.

Sealant - Liquid Gasket, TB1211F: 92014-0004
Check that dowel pins [B] are in place on the crankcase.
Replace the crankshaft sensor cover gasket with a new one.
Tighten: Torque - Crankshaft Sensor Cover Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)

Crankshaft Sensor Installation

Run the crankshaft sensor lead correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter).
Install the removed parts (see appropriate chapters).

Crankshaft Sensor Removal

Remove: Fuel Tank (see Fuel Tank Removal in the Fuel System (DFI) chapter) Crankshaft Sensor Lead Connector [A] Remove: Right Lower Fairing (see Lower Fairing Removal in the Fra ...

Crankshaft Sensor Inspection

Disconnect the crankshaft sensor lead connector (see Crankshaft Sensor Removal). Set the hand tester [A] to the × 10 Ω range and connect it to the crankshaft sensor lead connector ...

Other materials:

Gear Position Switch Removal
Remove: Oil Pump (see Oil pump Removal in the Engine Lubrication System chapter) Engine Sprocket (see Engine Sprocket Removal in the Final Drive chapter) Fuel Tank (see Fuel Tank Removal in the Fuel System (DFI) chapter) Disconnect the connector [A]. Remove: Screws [A] ...

Tire Removal
Remove: Wheels (see Front/Rear Wheel Removal) Valve Core (Let out the air) To maintain wheel balance, mark the valve stem position on the tire with chalk so that the tire can be reinstalled in the same position. Chalk Mark or Yellow Mark [A] Valve Stem [B] Align [C] Lu ...

Coupling Bearing Inspection
Since the coupling bearing is made to extremely close tolerances, the clearance can not normally be measured. NOTE It is not necessary to remove the coupling bearing for inspection. If the bearing is removed, it will need to be replaced with a new one. Turn the bearing in the coupling b ...