NOTE
Special Tools - Hand Tester: 57001-1394 Peak Voltage Adapter: 57001-1415 Type: KEK-54-9-B
Connections: Crankshaft Sensor Lead Connector Peak Voltage Adapter Hand Tester Y lead ← R lead → (+) BK lead ← BK lead → (–)
Crankshaft Sensor Peak Voltage Standard: 1.9 V or more
If the reading is less than the standard, inspect the crankshaft sensor (see Crankshaft Sensor Inspection).
Crankshaft Sensor Installation
Apply a non-permanent locking agent to the crankshaft
sensor bolts [A].
Tighten:
Torque - Crankshaft Sensor Bolts: 5.9 N·m (0.60 kgf·m, 52
in·lb)
Using a high flash-point solvent, clean off any oil or dirt
that may be on the silicone sealant coating area. Dry
them with a clean cl ...
Stem, Stem Bearing Installation
Replace the bearing outer races with new ones.
Drive them into the head pipe at the same time.
Special Tools - Head Pipe Outer Race Press Shaft [A]:
57001-1075
Head Pipe Outer Race Driver,
55 [B]: 57001
-1446 or Bearing Driver Set: 57001-1129
Apply grease to the outer races.
...
Side Stand
The motorcycle is equipped with a
side stand.
A. Side Stand
NOTE
When using the side stand, turn the
handlebar to the left.
Do not sit on the motorcycle while
it is on its side stand or centre stand.
Always kick the stand fully up before
sitting on the motorcycle.
NOTE
The motorcycl ...