If the clearance exceeds the service limit, replace the thrust washers as a set and check the width of the crankshaft #3 main journal.
Crankshaft Side Clearance
Standard: 0.05 0.25 mm
(0.0020 0.0098 in.)
Service Limit: 0.45 mm (0.0177 in.)
If the measurement exceeds the standard, replace the crankshaft.
Crankshaft #3 Main Journal Width
Standard: 23.49 23.54 mm (0.9248
0.9268 in.)
Damping Force Adjustment (
ZX1000JC/KC)
To adjust the damping force, turn the damping adjuster
[A] until you feel a click.
The standard adjuster setting is the 18th click from the
1st of the fully clockwise position. If the damping feels too
soft or too stiff, adjust it in accordance with the following
table.
Damping Force Adj ...
Swingarm Bearing, Sleeve Inspection
NOTICE
Do not remove the bearings for inspection. Removal
may damage them.
Inspect the needle bearings [A] and ball bearing installed
in the swingarm.
The rollers and ball in a bearing normally wear very little,
and wear is difficult to measure. Instead of measuring,
visually inspec ...
ECU Identification
Most countries have their own regulations, so each ECU
has different characteristic. So, do not confuse ECU with
each other and use only the ECU for your model. Otherwise,
the motorcycle can not clear the regulation.
ECU Identification
ZX1000JB/KB
ZX1000JC /KC
...