NOTE
Check the wheel alignment (see Wheel Alignment Inspection).
Rotate the rear wheel to find the position where the chain is tightest.
Measure the vertical movement (chain slack) [A] midway between the sprockets.
If the chain slack exceeds the standard, adjust it.
Chain Slack
Standard: 25 35 mm (1.0
1.4 in.)
Crankcase Assembly
NOTICE
The upper and lower crankcase halves are machined
at the factory in the assembled state, so the
crankcase halves must be replaced as a set.
With a high flash-point solvent, clean off the mating surfaces
of the crankcase halves and wipe dry
WARNINGGasoline and low flash-poin ...
Alternator Rotor Removal
Remove the alternator cover (see Alternator Cover Removal).
Clean off the oil from the outer circumference of the rotor.
Hold the alternator rotor steady with the rotor holder [A]
and suitable washer or plate [B].
Special Tools - Grip [C]: 57001-1591
Rotor Holder: 57001-1666
Flywheel P ...
Maintenance and adjustment
The maintenance and adjustments outlined in this chapter must be carried
out in
accordance with the Periodic Maintenance Chart to keep the motorcycle in good
running condition. The initial maintenance is vitally important and must not be
neglected.
With a basic knowledge of mechanics and the ...