Check 3-5: Warning Indicator Light (Red LED) (Oil Pressure Warning)
Inspection
Connect the leads in the same circuit as Check 3-2.
Connect the terminal [10] to the battery (–) terminal.
Check that the oil pressure warning symbol [A] and the
warning indicator light (Red LED) [B] go on.
If the indicator light does not go on, replace the meter unit.
...
Thermostat Inspection
Remove the thermostat (see Thermostat Removal).
Inspect the thermostat valve [A] at room temperature.
If the valve is open, replace the thermostat with a new
one.
To check valve opening temperature, suspend the thermostat
[A] in a container of water and raise the temperature
of ...
Hub Bearing Installation
Before installing the hub bearings, blow any dirt or foreign
particles out of the hub with compressed air to prevent
contamination of the bearings.
Replace the bearings with new ones.
Install the bearings by using the bearing driver set which
does not contact the bearing inner race.
...