1. Ignition Switch
2. Joint Connector E
3. ECU
4. Engine Ground
5. Battery
6. Starter Relay
7. Main Fuse 30 A
8. ECU Fuse 15 A
9. Frame Ground 2
10. Frame Ground 1
11. Fuse Box 1
12. Ignition Fuse 15 A
13. Joint Connector F
Relay Circuit Inspection
Remove the relay box (see Relay Box Removal).
Check conductivity of the following numbered terminals
by connecting the hand tester and one 12 V battery to the
relay box as shown in the figure (see Relay Box Internal
Circuit in this section).
If the tester does not read as specified, re ...
ESD Actuator Resistance Inspection
Turn the ignition switch to OFF.
Remove the electronic steering damper unit (see Steering
Damper Removal in the Steering chapter).
Connect a digitalmeter to the ESD actuator connector [A].
Measure the ESD actuator resistance.
ESD Actuator Resistance
Connections: BK lead [1] ← ...
Keys
This motorcycle has a combination
key, which is used for the ignition
switch, steering lock, seat lock, and
fuel tank cap.
Included with the key is a key number,
which may be stamped on a separate
plate. Record the key number in
the space provided and store the number
in a safe place. If y ...