Kawasaki Ninja Service Manual: Electric Starter System

IC Igniter Inspection

The IC igniter is built in the ECU [A]. Refer to the following items. Interlock Operation Inspection (see Interlock Operation Inspection) Ignition System Troubleshooting (see Ignition Syst ...

Starter Motor Removal

Drain the coolant (see Coolant Change in the Periodic Maintenance chapter). Remove: Thermostat (see Thermostat Removal in the Cooling System chapter) Slide out the rubber cap [A]. Re ...

Other materials:

Torque and Locking Agent
The following tables list the tightening torque for the major fasteners requiring use of a non-permanent locking agent or silicone sealant etc. Letters used in the “Remarks” column mean: AL: Tighten the two clamp bolts alternately two times to ensure even tightening torque. G: Apply ...

Pressure Testing
Remove: Upper Fairing Assembly (see Upper Fairing Assembly Removal in the Frame chapter) Radiator Cap [A] Remove the radiator cap in two steps. First turn the cap counterclockwise to the first stop. Then push and turn it further in the same direction and remove the cap. Install the ...

Spring Tension Inspection
Since a spring becomes shorter as it weakens, check its free length [A] to determine its condition. If the spring of either fork leg is shorter than the service limit, it must be replaced. If the length of a replacement spring and that of the remaining spring vary greatly, the remaining s ...