A two-color lead is identified first by the primary color and then the stripe color. Unless instructed otherwise, electrical leads must be connected to those of the same color.
Instrument
Use a meter that has enough accuracy for an accurate measurement. Read the manufacture’s instructions thoroughly before using the meter. Incorrect values may lead to improper adjustments.
Lubrication
Model IdentificationTechnical Information - Electronic Steering Damper (ESD/ZX1000JD/KD models)
1) Overview
This model has an Electronic Steering Damper (ESD)
[A]. Unlike conventional manual adjustment method of
Kawasaki, damping characteristics are adjusted by the
electronic control unit.
2) Purpose
Designed to offer increased stability at high speed without interfering with
light ...
Rear Shock Absorber Inspection
Remove the rear shock absorber (see Rear Shock Absorber
Removal).
Visually inspect the following items.
Smooth Stroke
Oil Leakage
Crack or Dent
If there is any damage to the rear shock absorber, replace
it.
Visually inspect the rubber bushing [A].
If it show any signs o ...
Stick Coil Input Voltage Inspection
NOTE
Be sure the battery is fully charged.
Turn the ignition switch to OFF.
Remove the ECU (see ECU Removal in the Fuel System
(DFI) chapter).
Do not disconnect the ECU connectors.
Connect a digital meter [A] to the connector [B] with the
needle adapter set.
Special Tool - N ...