1. Heat Insulation Rubber Plate
2. For Air Switching Valve Hoses (Place the air switching valve above the rubber plate.)
3. For Air Suction Valve Cover
4. For Throttle Body Assy Holder #2 and #3
5. For Throttle Body Assy Holder #1
6. For Water Temperature Sensor
7. Insert the tab into the slot.
8. For Throttle Body Assy Holder #4
9. For Air Bleeder Hose
10. For Starter Motor Cable
11. For Crankcase Breather Hose
Vehicle-down Sensor Installation
Be sure to install the rubber dampers [A] and collars [B]
on the bracket.
The UP mark [A] of the sensor should face upward.
WARNINGIncorrect installation of the vehicle-down
sensor
could cause sudden loss of engine power. The
rider could lose balance during certain ...
Backups
The ECU takes the following measures to prevent engine damage when the
DFI, ignition, S-KTRC
or immobilizer system parts have troubles.
Note:
(1): D-J Method: When the engine load is light like at idling or low
speed, the ECU determines the
injection quantity by calculating fr ...
Throttle Control System Inspection
Check the throttle grip free play [A].
If the free play is incorrect, adjust the throttle cables.
Throttle Grip Free Play
Standard: 2 3 mm (0.08
0.12 in.)
Check that the throttle grip [B] moves smoothly from full
open to close, and the throttle closes quickly and completely
by the ...